1.4 CYLINDER BLOCK [a] Make the first measurement along the fore-to-aft axis (axis A). [b] Make the second measurement 90 degrees away, along the side-to-side axis (axis B). [c] If there is more than 0.08 mm (0.003 inch) of wear, replace the cylinder liner. 4. Check the cylinder liner for out-of-round. If the two measurements vary by more than 0.010 mm (0.0004 in.), replace the cylinder liner. 5. Replace the cylinder liner, if required. Refer to section 1.4.1. 1.4.1.3 Measurement of Cylinder Liner Protrusion Measurement steps are as follows: 1. Clean the contact surfaces of the cylinder block, the cylinder liner, and the measuring plate. NOTE:
Correct cylinder liner protrusion is necessary to obtain a perfect seal when the head gasket is compressed by the cylinder head. 2. Install the liner and shim into the block without the seals. 3. Install the measuring plate (J–46180) on the cylinder block and cylinder liner. Fasten the measuring plate to the block by inserting the cylinder head bolts into the spacers and then threading them into the holes in the cylinder block. See Figure 1-22. 1. Cylinder Head Bolts Figure 1-22 Measuring Plate 4. Tighten the cylinder head bolts to 50 N·m (37 lb·ft). All information subject to change without notice. 1-28 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION