Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 2. Measure the inside diameter of the cylinder liner at measuring point 1: near the O-ring area. See Figure 1-20. Figure 1-20 Measuring the Inside Diameter [a] Make the first measurement along the fore-to-aft axis. [b] Make the second measurement 90 degrees away, along the side-to-side axis. [c] When finished, set the dial gauge to zero. 3. Measure the wear on the inside diameter of the cylinder liner at measuring point 2: the upper reversal point of the first piston ring. Measure the cylinder liner in both directions: fore-to-aft and side-to-side. See Figure 1-21. The specifications are listed in Table 1-9. 1. Cylinder Liner 2.

Measuring Point 2 (upper reversal point of the first piston ring) Figure 1-21 Measuring Points All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-27