Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

14.1 SCHEDULED INTERVALS NOTICE: When flushing the radiator, do not apply more than 140 kPa (20 psi) air pressure. Excessive pressure can damage the radiator or heater core. 4. Flush the radiator. [a] Attach a flushing gun nozzle to the radiator outlet. [b] Run water in until the radiator is full. [c] Apply no more than 140 kPa (20 psi) air pressure intermittently to help dislodge sediment buildup in the core. 5. Drain the radiator, and flush the radiator until clean water flows from the radiator. Remove the flushing gun. 6. When the coolant has drained, install the coolant drain plug on the radiator. 7.

Add coolant in the specified concentration until the maximum mark on the surge tank is reached. The coolant system capacity is listed in Table 14-8. ENGINE EXHAUST To avoid injury from inhaling engine exhaust, always operate the engine in a well-ventilated area. Engine exhaust is toxic. 8. Start the engine and run it for about one minute at varying speeds to release air pockets in the cooling system. Make sure the heater valve is still open. Check the coolant level and add more coolant if necessary. 9. Shut down the engine. 10. Close and tighten the cap on the surge tank. 14.1.10 Cooling System Inspecting Inspect the cooling system as follows: All information subject to change without notice.

14-20 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION