EPA07 MBE 4000 SERVICE MANUAL HOT COOLANT To avoid scalding from the expulsion of hot coolant, never remove the cooling system pressure cap while the engine is at operating temperature. Wear adequate protective clothing (face shield, rubber gloves, apron, and boots). Remove the cap slowly to relieve pressure. 1. Open the cap on the surge tank slowly, to allow excess pressure to escape. Set the cap aside. 2. Open the water regulating valve for the heating system. 3. Drain the coolant from the engine. The coolant system capacity is listed in Table 14-8. *Does not include capacity of cooling system. †With 1200 sq. in. radiator.
Table 14-8 Coolant Capacity [a] Place a receptacle underneath the coolant drain plug. Choose one that is large enough to hold the expected quantity of coolant. NOTE: Make sure the coolant can flow unobstructed into the receptacle. [b] Open the coolant drain plug on the bottom of the radiator. All information subject to change without notice.
DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 14-19 System Description Capacity L (qts) Engine Coolant Capacity (all vehicles) Engine capacity* 30.0 (31.7) Century Class and Columbia Cooling System Capacity Total capacity† 57.4 (60.7) Antifreeze quantity at 50% 57.4 (60.7) Antifreeze quantity at 60% 34.4 (36.4) Sterling A-Line and L-Line Cooling System Capacity Total capacity 53.8 (56.8) Antifreeze quantity at 50% 26.9 (28.4) Antifreeze quantity at 60% 32.3 (34.1) FL112 Cooling System Capacity Total capacity 42.0 (44.4) Antifreeze quantity at 50% 21.0 (22.2) Antifreeze quantity at 60% 25.2 (26.6)