EPA07 MBE 4000 SERVICE MANUAL 15.1 PREPARING ENGINE FOR STORAGE It will be necessary to remove all rust or corrosion completely from any exposed part before applying rust preventive compound. Therefore, it is recommended that the engine be processed for storage as soon as possible after removal from operation. The engine should be stored in a building that is dry and can be heated during the winter months. Moisture-absorbing chemicals are available commercially for use when excessive dampness prevails in the storage area. 15.1.1 Cleaning the Engine Please follow the equipment manufacturer's operating instructions for using high-pressure cleaning equipment.
Information on suitable cleaning and protective products is available from any authorized dealer. NOTICE: To prevent damage to engine components during the cleaning process, keep the water moving at all times. Never direct water onto electrical components, plug connectors, seals or flexible hoses. Comply with the minimum working distance between the high-pressure nozzle and the surface being cleaned: Approximately 700 mm (28 in.) for circular pattern jets Approximately 300 mm (12 in.) for 25-degree flat jets and dirt cutters 15.1.2 Cleaning the Cooling System Clean the cooling system as follows: NOTE: Collect the used coolant, cleaning solutions, and washing liquids.
Dispose of them in accordance with applicable laws regarding the protection of the environment. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 15-3