15.1 PREPARING ENGINE FOR STORAGE NOTICE: Clean at moderate pressures only; otherwise the fins of the radiator grille could be damaged. EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. 1. Remove debris (dust, insects, etc.) from the fins of the radiator grille by blowing them through with compressed air or spraying them out with water. Work from the rear of the radiator (in the opposite direction of the normal cooling air flow). 2. Drain the coolant when the engine is cold. For detailed procedures, see the vehicle/chassis maintenance manual. 3.
If the heat, ventilation, and air conditioning (HVAC) unit is connected to the cooling system, open the regulating valves all the way. 15.1.3 Degreasing the Cooling System Degrease the cooling system as follows: 1. Fill the cooling system with a 5% solution (1.6 ounces per quart of water—50 grams per liter) of a mildly alkaline cleaning agent, such as sodium carbonate. ENGINE EXHAUST To avoid injury from inhaling engine exhaust, always operate the engine in a well-ventilated area. Engine exhaust is toxic. 2. Run the engine at moderate speed until the thermostat starts to open, at an operating temperature of approximately 80°C (176°F). Then run it for about five minutes longer.
Shut down the engine and allow it to cool to approximately 50°C (122°F). 3. Drain all the cleaning solution. 4. Flush the cleaning solution from the cooling system. [a] Immediately after draining the cleaning solution, flush the system with clean water. [b] Once the clean water has drained, fill the system again with clean water. [c] Run the engine. Allow the engine to warm up to approximately 80°C (176°F), and then run it about five minutes longer. All information subject to change without notice. 15-4 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION