EPA07 MBE 4000 SERVICE MANUAL [d] Drain the hot water. 5. Fill the cooling system with new coolant. For detailed procedures, see the vehicle/chassis maintenance manual. For types of coolant, refer to the coolant selections guide, Coolant Requirements for Engine Cooling Systems (7SE298). 15.1.4 Storage Required protective measures for the MBE 4000 engine depend on the following: The length of time that the engine will be out of service The climate and conditions where the engine is stored After cleaning, engines should, whenever possible, be placed in a dry, well-ventilated place. In all cases, protect the engine against direct exposure to moisture (rain/splash water).
If the engine is to be out of service for 12 months or less, anticorrosion measures are not necessary, provided that the place of storage are dry and well–ventilated as described above. If the engine is to be out of service for over 12 months, or under extraordinary storage or transportation conditions, then special protective measures are necessary. 15.1.5 Temporary Storage (30 Days or Less) To protect the engine for a temporary period of time (30 days or less), follow this procedure: 1. With the engine at ambient temperature and cool to the touch, drain engine crankcase oil into a suitable container.
Dispose of the oil in an environmentally friendly manner, according to state and/or federal EPA recommendations. 2. Fill the crankcase to the proper level with the recommended viscosity and grade of oil. 3. Fill the fuel tank with the recommended grade of fuel oil. Operate the engine for two (2) minutes at 1200 rpm and no load. Do not drain the fuel system or the crankcase after this run. 4. Check the air cleaner and service it, if necessary. 5. If freezing weather is expected during the storage period, check the antifreeze/coolant for required freeze and inhibitor protection. Add antifreeze solution to the cooling system as necessary. NOTE:
If an antifreeze solution is not required during storage, flush the cooling system with a good soluble oil (3% 5% by volume) rust inhibitor to prevent rusting of the outside diameter of the cylinder liners. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 15-5