Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

15.1 PREPARING ENGINE FOR STORAGE EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. 6. Clean the exterior of the engine (except electrical parts) with fuel oil and dry with compressed air. 7. Seal all engine openings. The material used must be waterproof, vaporproof and possess sufficient physical strength to resist puncture and damage from the expansion of entrapped air.

An engine prepared in this manner can be returned to service in a short time by removing the seals at the engine openings and by checking the engine coolant, fuel oil, lubricating oil and transmission oil levels. 15.1.6 Extended Storage (More than 30 Days) To prepare an engine for extended storage (more than 30 days), follow this procedure: 1. Drain the cooling system and flush with clean, soft water. Refill with clean, soft water and add a rust inhibitor to the cooling system. 2. Circulate the coolant by operating the engine until normal operating temperature is reached. 3. Stop the engine. 4.

With the engine at ambient temperature and cool to the touch, drain the engine crankcase oil into a suitable container. Remove the oil filters. Dispose of the oil and filters in an environmentally friendly manner, according to state and/or federal EPA recommendations. Replace the drain plug and tighten to 80 N·m (59 lb-ft) torque. 5. Install new lubricating oil filters. Fill the crankcase to the proper level with Tectyl® 930A preservative lubricating oil or an equivalent 30–weight preservative lubricating oil meeting Mil-L-21260C, Grade 2 Specification. 6. Drain the fuel tank. Refill with enough clean No. 1 diesel fuel or pure kerosene to permit the engine to operate for about ten (10) minutes.

If draining the fuel tank is not convenient, use a separate, portable supply of recommended fuel. NOTE: If engines are stored where condensation of water in the fuel tank may be a problem, additives containing methyl carbitol or butyl cellusolve may be added to the fuel. Follow manufacturer's instructions for treatment. Where biological contamination of fuel may be a problem, add a biocide such as Biobor® JF (or equivalent) to the fuel. When using a biocide, follow the manufacturer's concentration recommendations and observe all cautions and warnings. All information subject to change without notice. 15-6 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION