1.4 CYLINDER BLOCK 6. Measure the cylinder liner protrusion from the block in four places, once at each slot in the measuring plate. See Figure 1-24. The acceptance/rejection criteria is listed in Table 1-10. 1. Collar Seat Insert (shim) 4. Liner Seat D-Ring 2. Cylinder Block A. Specified in Measuring Cylinder Liner Protrusion Table 3. Cylinder Liner Figure 1-24 Measuring Protrusion Table 1-10 Specifications for Measuring Cylinder Liner Protrusion [a] Set the scale on the dial gauge to zero. [b] Move the dial gauge until the feeler touches the cylinder liner collar. Record the reading on the dial gauge.
[c] Move the dial gauge and support to the next slot, and repeat the measurement process, until four measurements have been made, one at each slot. Record each measurement. [d] Check each measurement. If any one measurement records protrusion of less than 0.230 mm (0.0090 in.), or more than 0.330 mm (0.0130 in.), remove the cylinder liner and check it according to the procedures that refer to section 1.4.1. NOTE: There are three different cylinder liner shim thicknesses that are available, 0.15mm, 0.30mm and 0.50mm. [e] Compare the four measurements.
If any measurement differs from any one of the others by more than 0.02 mm (0.0008 in.), replace the cylinder liner and repeat All information subject to change without notice. 1-30 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION Description Dimensions: mm (in.) Cylinder Liner Protrusion From Block 0.230–0.330 (0.0090–0.0130) Difference Between the Four Measuring Points Max.: 0.02 (0.0007)