Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL steps “a” through “e”. If the cylinder liner measurements are within specification continue to step 7. 7. Remove the bolts, spacers and measuring plate, as installed. 1.4.1.4 Testing of Fuel System Fuel system leak testing steps are as follows: NOTE: This procedure can be performed with the engine installed or removed from the vehicle. FIRE To avoid injury from fire, keep all potential ignition sources away from diesel fuel, including open flames, sparks, and electrical resistance heating elements. Do not smoke when refueling. 1. Drain all fuel from engine. 2. Remove all six injector unit pumps from the engine block. Refer to section 2.1.1. 3.

Install all six dummy unit pumps (J–45982–6–1), from the Head and Block Leak Tester Tool Kit (J–45982). See Figure 1-25. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-31