Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL NOTICE: Do not apply oil, grease, or any wax base compound to the flywheel. The case iron will absorb these substances, which can sweat out during operation and cause the clutch to slip. 16. Apply a non–friction rust preventive compound to all exposed engine parts. If convenient, apply the rust preventive compound to the engine flywheel. If not, disengage the clutch mechanism to prevent the clutch disc from sticking to the flywheel. NOTICE: Incomplete draining of the water pump may result in rusting of the impeller to the pump body during extended engine storage, especially if inadequate inhibitor was used in the remaining coolant.

Damage from freezing temperatures may occur if the coolant remaining in the engine has insufficient antifreeze to prevent it from freezing and expanding. To ensure complete pump drainage, always remove the drain plug from the bottom of the pump before extended storage. If a coolant filter/inhibitor system hose is attached to the bottom of the pump, disconnect the hose and allow the pump to drain completely. Open the drain cock at the bottom of the filter. Do not reinstall the pump drain plug or filter hose or retighten the filter drain plug until the engine is put back into service. 17. Drain the engine cooling system. 18. Drain the preservative oil from the engine crankcase. 19.

Remove and clean the battery and battery cables with a baking soda–water solution and rinse with fresh water. Do not allow the baking soda solution to enter the battery. 20. Add distilled water to the electrolyte (if necessary) and fully charge the battery. NOTICE: To avoid possible battery damage caused by freezing, never store a battery in a place below 0°C (32°F). 21. Store the battery in a cool, dry place. Keep the battery fully charged and check the level and specific gravity of the electrolyte regularly. 22. Insert heavy paper strips between the pulleys and drive belts to prevent sticking. 23. Seal all engine openings including the exhaust outlet, with moisture resistant tape.

Use cardboard, plywood, or metal covers where practical. 24. Clean and dry the exterior painted surfaces of the engine and spray with a suitable liquid automobile body wax, a synthetic resin varnish, or a rust–preventive compound. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 15-11