EPA07 MBE 4000 SERVICE MANUAL 8. Measure the cylinder liner protrusion from the block. See Figure 1-15. The specifications are listed in Table 1-11. Table 1-11 Cylinder Liner Installation Tolerances 9. Measure the inside diameter of the cylinder liner and check for out-of-round. See Figure 1-36. 1. Cylinder Liner 3. Dial Gauge 2. Quick Calipers 4. Cylinder Block Figure 1-36 Measuring the Cylinder Liner Inside Diameter [a] Measure at three different locations 60 degrees apart in the area of the two O-rings. [b] Compare the three measurements.
If they differ by more than the maximum admissible out-of-round listed in Table 1-8, remove the cylinder liner and inspect the two O-rings and their seating area in the cylinder block. [c] If the O-rings are damaged, replace them. [d] Check the out-of-round again until it meets specifications. 10. Install the piston. Refer to section 1.19.2. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-41 Description Dimensions: mm (in.) Cylinder Liner Protrusion, From Block, see Figure 1-15, Ref. A.
0.230–0.330 (0.0090–0.0130) Height of the Cylinder Liner Collar, see Figure 1-15 10.10–10.12 (0.3976–0.3984) Depth of the Collar Seat, see Figure 1-15 9.950–10.010 (0.3917–0.3941) Thickness of the Seat Insert 0.14–0.16 (0.0055–0.0063)