1.4 CYLINDER BLOCK 7. Install the cylinder liner, using the cylinder liner installation tool (J–46168). See Figure 1-35. 1. Installation Nut 3. Cylinder Block 2. Cylinder Liner Figure 1-35 Cylinder Liner Do not overtighten the installation tool. This may deform the cylinder liner and make the installation tool more difficult to remove. NOTICE: [a] Tighten the installation tool just enough to hold the installation tool inside the cylinder liner without turning. NOTICE: To prevent damage to the O-rings, the cylinder liner must be rotated during installation. NOTE: If installing the old cylinder liner, offset the reference marks 90 degrees from the previous ones.
[b] Insert the cylinder liner into the cylinder block until it contacts the O-rings. Continue to insert the cylinder liner past the O-rings, being careful to keep turning the installation tool until the cylinder liner is properly seated. [c] Remove the installation tool from the cylinder liner. All information subject to change without notice. 1-40 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION