EPA07 MBE 4000 SERVICE MANUAL 1.6.1 Removal of Constant Throttle Valve Removal steps are as follows: 1. Remove the cylinder head. Refer to section 1.3.1. 2. Remove the fuel injector nozzle. Refer to section 2.6.1. 3. From the top of the cylinder head, remove the end cover on the constant-throttle valve. See Figure 1-39. 1. End Cover 7. Spring 2. O-ring 8. Spring Guide 3. Piston Seal 9. Valve Stem Seal 4. Piston 10. Valve 5. Valve Keepers 11. Cylinder Head 6. Spring Retainer Figure 1-39 Constant-Throttle Valve NOTE: Insert a spacer beneath the valve head to prevent the valve from opening while doing the rest of the removal procedures. See Figure 1-40.
All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-45