Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 1.9 CRANKSHAFT WEAR SLEEVE The crankshaft wear sleeve is used on the front or rear of the crankshaft in conjunction with an oversize seal. These special tools are required for this procedure: Seal and Wear Sleeve Service Kit, J-47273 Universal Driver Handle, (J–8092, part of toolset J-47273) Front/Rear Wear Sleeve Installer, (J-45989, part of service kit J–47273) Front/Rear Wear Sleeve Installer, (J-47271, part of service kit J–47273) 1.9.1 Removal of Front Crankshaft Wear Sleeve Removal steps are as follows:

PERSONAL INJURY To avoid injury before starting and running the engine, ensure the vehicle is parked on a level surface, parking brake is set, and the wheels are blocked. 1. Park the vehicle on a level spot, set the parking brakes, and chock the tires. 2. Tilt the hood. 3. From underneath the front of the engine, remove the bumper beam. Push the support angle bracket fairing down to create an opening in the bumper. 4. Remove the vibration damper and pulley from the engine through the opening in the bumper. Refer to section 1.13.1. 5. Remove the front radial seal. Refer to section 1.7.1. 6. Clean the wear sleeve seat area on the crankshaft. All information subject to change without notice.

DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-57