Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

1.8 REAR RADIAL SEAL [b] Install two seal guide pins (J-47067–4, part of toolset J–47067 and service kit J-47273). See detail “B” in Figure 1-49. 1. Flywheel Housing 3. Seal 2. Crankshaft Figure 1-49 Rear Oversize Crankshaft Seal NOTE: The oversize rear radial seal has in inside diameter of 120.0 mm (4.72 in.). [c] Put the new radial seal in place on the rear seal installer, (J–47067–1, part of toolset J–47067 and service kit J–47273). See detail “C” in Figure 1-49. [d] Slide the seal installer (J–47067–1, part of toolset J–47067 and service kit J–47273), over the guide pins (J–47067–4) part of toolset J–47067 and service kit J–47273) and position the seal into the flywheel housing.

See detail “D” in Figure 1-49. [e] Install the forcing screw (24833, part of toolset J–47067 and service kit J–47273) and crossbar (26603, part of toolset J–47067 and service kit J–47273) onto the guide pins. See detail “D” in Figure 1-49. [f] Install the seal by turning the forcing screw until the tool bottoms on the butt of the crankshaft. [g] Remove the tool and visually check the seal and sealing lip for correct installation. [h] Install the flywheel. Refer to section 1.14.2. All information subject to change without notice. 1-56 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION