EPA07 MBE 4000 SERVICE MANUAL 1.8.2 Installation of Rear Radial Seal Installation steps are as follows: NOTE: The radial seal does not need to be lubricated. 1. Inspect the contact surface of the flywheel for damage and wear. If it is scored or worn, replace it. 1. Rear Radial Seal Figure 1-48 Rear Radial Seal NOTE: The standard size rear radial seal has an inside diameter of 115.0 mm (4.53 in.). 2. To replace a standard rear crankshaft seal do the following: [a] Place the seal installer guide, (J–45393–1, part of toolset J–45393–A and service kit J–47273), on the end of the crankshaft. See Figure 1-48.
[b] Put the new radial seal in place on the rear seal installer, (J–45393–2, part of toolset J–45393–A and service kit J–47273). See Figure 1-48. [c] Position the rear seal installer on the receptacle, and drive the seal in until it bottoms out. 3. To replace an oversize rear crankshaft seal do the following: [a] Install the crankshaft rear wear sleeve. Refer to section 1.9.4. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-55