1.8 REAR RADIAL SEAL 1.8 REAR RADIAL SEAL The below listed special tools are required for this procedure. Rear Seal Puller, J–46188 (part of service kit J–47273) Rear Seal Puller (std seal), J–45393–A (part of service kit J–47273) Front/Rear Oversize Seal Installer Kit, J–47067 (part of service kit J–47273) Seal and Wear Sleeve Service Kit, J-47273 1.8.1 Removal of Rear Radial Seal Removal steps are as follows: 1. Remove the flywheel. 1. Rear Radial Seal 3. End of Crankshaft 2. Flywheel Housing Figure 1-47 Rear Radial Seal NOTICE: When drilling pilot holes for the removal of seal ensure that the drill is straight and perpendicular to the seal.
Failure drill the hole straight could result in damage to the seal bore, resulting in the replacement of the flywheel housing. NOTE: When drilling holes for screws, make sure to coat the drill bit with grease to catch the shavings. 2. Drill 3.174 mm (0.125 in.) pilot holes and use the sheet metal screws and the rear seal puller J–46188 (part of service kit J–47273) , remove the rear radial seal from the flywheel housing. Discard the seal. See Figure 1-47. All information subject to change without notice. 1-54 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION