EPA07 MBE 4000 SERVICE MANUAL 2. Slide the seal over the center guide (J–45391–2, part of toolset J–45391 and service kit J–47273). Place the guide on the front of the crankshaft. Fit the front seal installer (J–45391–1,part of toolset J–45391 and service kit J–47273) over the guide and tap it into the front cover housing until it bottoms. Visually check the seal and sealing lip for correct installation. 1. Front Radial Seal 2. Front Cover Housing Figure 1-46 Front Radial Seal 3. Install the oil deflector on the front cover housing. See Figure 1-46. 4. Install the vibration damper and pulley on the crankshaft. Tighten the vibration damper mounting bolts to 200 N·m (148 lb·ft).
See Figure 1-46. 5. Install the main drive belt. Refer to section 9.1.2. 6. Install the fan drive belt. Refer to section 9.1.4. 7. Install the support angle bracket fairing. Install the bumper beam. To avoid injury from inhaling engine exhaust, always operate the engine in a well-ventilated area. Engine exhaust is toxic. ENGINE EXHAUST 8. Start the engine and check the engine oil pressure at idle. Engine oil pressure at idle should be at least 50 kPa (7 psi). Looks for any oil leaks, repair as necessary. 9. Close the hood, and remove the chocks from the tires. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-53