Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

1.7 FRONT RADIAL SEAL NOTICE: the hole straight could result in damage to the seal bore, resulting in the replacement of the front cover housing. NOTE: When drilling holes for screws, make sure to coat the drill bit with grease to catch the shavings. 1. Front Radial Seal 2. Front Cover Housing 3. Screws Figure 1-45 Front Radial Seal 6. Drill 3.174 mm (0.125 in.) pilot holes and use the sheet metal screws and the front seal puller (J–47272, part of toolset J–47273), remove the front radial seal from the front cover housing. Discard the seal. 7. If installed, check wear sleeve for nicks, scratches or grooves. If necessary, replace wear sleeve. Refer to section 1.9.1.

1.7.2 Installation of Front Radial Seal Installation steps are as follows: NOTE: The radial seal does not need to be lubricated. 1. Clean the sealing surfaces on the cover and the cylinder block. NOTE: The seal installation is the same for a standard size and oversize front radial seal. The front standard size radial seal has an inside diameter of 100.0 mm (3.94 in.). The oversize radial seal has an inside diameter of 105.0 mm (4.13 in.). All information subject to change without notice. 1-52 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION