Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 1.7 FRONT RADIAL SEAL The following sections support the repair of the front radial seal. 1.7.1 Removal of Front Radial Seal Removal steps are as follows: Two special tools are required for this procedure: Front Seal Puller (J–47272) Front Seal Installer (J–45391) PERSONAL INJURY To avoid injury before starting and running the engine, ensure the vehicle is parked on a level surface, parking brake is set, and the wheels are blocked. 1. Park the vehicle on a level spot, set the parking brakes, and chock the tires. 2. Tilt the hood. 3. From underneath the front of the engine, remove the bumper beam.

Push the support angle bracket fairing down to create an opening in the bumper. 4. Remove the vibration damper and pulley from the engine through the opening in the bumper. Refer to section 1.13.1. 5. Check the seal for leaks at the places where it contacts the crankshaft. NOTICE: When drilling pilot holes for the removal of the seal ensure that the drill is straight and perpendicular to the seal. Failure to drill All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-51