Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

1.6 ENGINE BRAKE 8. Position CTV solenoid socket (J–47398) under the exhaust manifold and between the engine and oil cooler. 9. Slide the socket from rear to front until it is positioned over the solenoid. NOTICE: Ensure that the CTV solenoid harness does not get pinched . Damage to the harness could cause engine braking problems. 10. Using a 3/8 in. drive extension and a universal swivel remove the CTV solenoid. 11. Remove the O-ring from the solenoid and discard. 1.6.4 Installation of Constant Throttle Valve Solenoid Installation steps are as follows: 1. Install a new O-ring on the CTV solenoid and lubricate with clean engine oil. 2.

Position the CTV solenoid into the oil cooler housing and start threads by hand. NOTICE: Ensure that the CTV solenoid harness does not get pinched . Damage to the harness could cause engine braking problems. 3. Using a 3/8 in. drive extension and a universal swivel torque, the CTV solenoid to 35 N·m (26 lb·ft). 4. Connect the harness connectors to the CTV solenoid, Oil Pressure/Temperature Sensor, and EPV solenoid. Secure harness with nylon tie straps. 5. Installed the removed lower exhaust manifold heat shield. Torque the bolts to 25 N·m (18 lb·ft). All information subject to change without notice. 1-50 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION