Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 8. Install the assembled tool J–45989 into place by sliding from the bottom up along the rear of the wear sleeve. See Figure 1-51. Figure 1-51 Front Seal Wear Sleeve 9. Turn the forcing screw in a slow and continuous motion until the wear sleeve is removed. NOTE: Once the wear sleeve is fully removed the tool will drop. Use care to support the tool during the removal procedure. 1.9.2 Installation of Front Crankshaft Wear Sleeve Installation steps are as follows: 1. Clean the wear sleeve seat area on the crankshaft. BURNS To avoid injury from burning, use lifting tools and heat-resistant gloves when handling heated components.

Be sure to heat the new wear sleeve as evenly as possible. If available, an oven should be used. Uneven heating of the wear sleeve can weaken the material and reduce the service life. NOTICE: 2. Install the wear sleeve with the rounded edge toward the inside of the wear sleeve installer tool (J–47271, part of toolset J-47273). Heat the tool and sleeve together in an oven to a maximum of 150° C (302°F). All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-59