Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

1.9 CRANKSHAFT WEAR SLEEVE 3. Remove the tool and sleeve from the oven and thread driver handle (J–8092, part of toolset J-47273) into the wear sleeve installer tool (J–47271, part of toolset J-47273). NOTICE: Ensure that the rounded edge of the wear sleeve faces out and is flush with the crankshaft. The installer tool guarantees the wear sleeve position onto the crankshaft. Falling to use the correct tool may affect the service life of the seal. 4. Drive the wear sleeve onto the front of the crankshaft. 5. Wait until the wear sleeve cools to room temperature before installing the oversize radial seal. Refer to section 1.7.2 to install the front oversize radial seal.

1.9.3 Removal of Rear Crankshaft Wear Sleeve Removal steps are as follows: 1. Remove the flywheel. Refer to section 1.14.1. 1. Flywheel Figure 1-52 Rear Wear Sleeve Tool J-45989 2. Position the assembled wear sleeve removal to (J–47271, part of toolset J-47273) ensuring that the plate is positioned behind the lip of the wear sleeve. See Figure 1-52. NOTE: Lubricate the forcing screw with the supplied high-pressure lubricant. All information subject to change without notice. 1-60 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION