Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

EPA07 MBE 4000 SERVICE MANUAL 3. Turn the forcing screw until the wear sleeve has been removed from the flywheel. Discard the wear sleeve. See Figure 1-53. 1. Wear Sleeve 2. Flywheel Figure 1-53 Wear Sleeve 1.9.4 Installation of Rear Crankshaft Wear Sleeve Installation steps are as follows: 1. Remove the flywheel. Refer to section 1.14.1. 2. Install the wear sleeve with the rounded edge toward the inside of the wear sleeve installer tool (J–47271, part of toolset J-47273). Heat the tool and sleeve together in an oven to a maximum of 150° C (302°F). BURNS To avoid injury from burning, use lifting tools and heat-resistant gloves when handling heated components. NOTICE:

Be sure to heat the new wear sleeve as evenly as possible. If available, an oven should be used. Uneven heating of the wear sleeve can weaken the material and reduce the service life. 3. Remove the tool and sleeve from the oven and thread driver handle (J–8092, part of toolset J-47273) into the wear sleeve installer tool (J–47271, part of toolset J-47273). All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-61