1.9 CRANKSHAFT WEAR SLEEVE NOTICE: Ensure that the rounded edge of the wear sleeve faces out and is flush with the crankshaft. The installer tool guarantees the wear sleeve position onto the crankshaft. Falling to use the correct tool may affect the service life of the seal. 4. Drive the wear sleeve onto the flywheel hub area. 5. Wait until the wear sleeve cools to room temperature before installing the oversize radial seal. Refer to section 1.7.2 to install the front oversize radial seal. All information subject to change without notice. 1-62 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION