Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

1.10 CRANKSHAFT ASSEMBLY 1.10.1 Removal of Crankshaft Removal steps are as follows: FALLING ENGINE To avoid injury from a falling engine, an adequate lifting device with a spreader bar and sling should be used to lift the engine. The sling and spreader bar should be adjusted so the lifting hooks are vertical to prevent bending the lifter brackets. To ensure proper weight distribution, all provided lifter brackets must be used. NOTICE: A spreader bar must be used at all times in conjunction with the front and rear lifter brackets to lift the EGR engine to ensure that no engine damage will result. The brackets are designed to lift vertically. 1. Remove the engine from the vehicle.

FALLING ENGINE To avoid injury from a falling engine, ensure the engine is securely attached to the engine overhaul stand before releasing the lifting sling. 2. Mount the engine on an engine stand. Install the engine on an engine stand. Use OTC engine stand 1750A or equivalent and engine stand adaptor plate J-41576. 3. Remove the cylinder heads. Refer to section 1.3.1. 4. Remove the oil pan. Refer to section 3.2.1. 5. Remove oil pump. Refer to section 3.5.1. 6. Remove the flywheel. Refer to section 1.14.1. 7. Remove the flywheel housing. Refer to section 1.18.1. 8. Remove the front cover housing. Refer to section 1.11.1. 9. Remove the pistons. Refer to section 1.19.1.

All information subject to change without notice. 1-64 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION