EPA07 MBE 4000 SERVICE MANUAL 15. Lift the crankshaft out of the cylinder block. Make sure the crankshaft doesn't twist from side to side. See Figure 1-58. 1. Crankshaft 3. Hook of Hoisting Chain 2. Flexible Straps 4. Cylinder Block Figure 1-58 Lifting the Crankshaft [a] Lower the crankshaft gently onto a flat surface covered with clean cardboard. [b] Remove the hoist. 16. Mark each upper bearing shell and its corresponding race before removing the bearing shells from the crankcase. 17. Check all parts for wear or damage. Measure the various crankshaft specifications. Refer to section 1.10.2.3. 1.10.2 Installation of Crankshaft Install the crankshaft as follows: 1.
Clean the crankshaft oil passages with a wire brush and blow compressed air through the passages. Clean the crankshaft, bearings, and bearing seats with a chamois. 2. Lubricate the bearing surfaces with a light coating of clean engine oil. 3. Install the upper bearing shells into the block, in the same order as they were removed. Make sure the locking lugs of the bearing shells fit into the slots of the block bores. Refer to section 1.10.2.2. NOTE: The center bearing shell halves must be mounted in the center crankcase race and bearing cap (fourth from either end). All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-67