1.10 CRANKSHAFT ASSEMBLY 4. Install the lower bearing shells into the main bearing caps, in the same order as they were removed. Make sure the locking lugs are fully seated in the grooves of the bearing caps. Refer to section 1.10.2.2. 5. Screw a crankshaft and flywheel guide pin into each end of the crankshaft. FALLING COMPONENT To avoid injury from a falling component, ensure a proper lifting device is used. 6. Using a suitable hoist, lower the crankshaft into the block. 7. As you set the crankshaft into the block, use the guide pins to maneuver the crankshaft into position to align the crankshaft gear with the camshaft gear.
Fit the marked gear tooth on the crankshaft gear between the two marked teeth on the camshaft gear. See Figure 1-55. 8. Install all the main bearing caps (including the center bearing cap), with their bearing shells, on the crankcase journals, as removed. See Figure 1-56. NOTE: Make sure the numbers on the bearing caps are in ascending order, starting from the front of the engine. 9. Measure the shaft length of the main bearing-cap bolts. Replace any bolts that exceed the maximum shaft length of 156.0 mm (6.14 in.). See Figure 1-59. 1. Main Bearing-Cap Bolt Figure 1-59 Measuring a Main Bearing-Cap Bolt All information subject to change without notice.
1-68 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION