EPA07 MBE 4000 SERVICE MANUAL 10. Lubricate the main bearing-cap bolts with a light coating of clean engine oil. Install all the M18 x 2 main bearing-cap bolts, in the correct order, as removed. Tighten each one in four stages, listed in Table 1-12, stage by stage. Table 1-12 Tightening Stages, Main Bearing-Cap Bolts 11. Measure the crankshaft end play (fore-to-aft motion) at the center bearing journal. Refer to section 1.10.2.1. 12. Install the pistons. Refer to section 1.19.2. 13. Install the oil pump. Refer to section 3.5.3. 14. Install the oil pan. Refer to section 3.2.2. 15. Install the flywheel housing. Refer to section 1.18.2. 16. Install the flywheel. Refer to section 1.14.2. 17.
Install the front cover housing. Refer to section 1.11.2. 18. Install the cylinder heads. Refer to section 1.3.2. FALLING ENGINE To avoid injury from a falling engine, an adequate lifting device with a spreader bar and sling should be used to lift the engine. The sling and spreader bar should be adjusted so the lifting hooks are vertical to prevent bending the lifter brackets. To ensure proper weight distribution, all provided lifter brackets must be used. NOTICE: A spreader bar must be used at all times in conjunction with the front and rear lifter brackets to lift the EGR engine to ensure that no engine damage will result. The brackets are designed to lift vertically. 19.
Remove the engine from the stand. 20. Install the engine in the vehicle. All information subject to change without notice. DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION 1-69 Max. Shaft Length: mm (in.) Tightening Stage Torque: N·m (lb·ft) 156.0 (6.14) Stage 1 100 (74) 156.0 (6.14) Stage 2 200 (148) 156.0 (6.14) Stage 3 300-330 (221-243) 156.0 (6.14) Stage 4 90 degrees