Detroit Diesel — Print Preview - C:\DOCUME~1\jcampb01\LOCALS~1\Temp\.aptcache\compdisp049\compdisp

1.10 CRANKSHAFT ASSEMBLY 1.10.2.1 Measurement and Inspection of Crankshaft Inspection steps are as follows: 1. Remove the crankshaft. Refer to section 1.10.1. 2. Clean the crankshaft with a chamois. 3. Check the crankshaft for condition. If cracks or fissures are found, replace the crankshaft. 4. Test the hardness of the journals. Each journal must pass the hardness test at two thirds of its circumference. If it doesn't, either replace the crankshaft, or have it re-hardened. See Table 1-13 for hardness specifications [a] Place a hard base underneath the bearing journal to be tested. [b] Test hardness all the way around the journal circumference.

Hardness must be 53 to 59 HRC as listed in Table 1-13. * Except as otherwise noted. †Measure with the crankshaft mounted on the outer main bearing journals. ‡With the pin for the flywheel installed, but without the flywheel, and with the crankshaft mounted on the outer bearings. Table 1-13 Crankshaft Specifications 5. Measure the deviation from true of the crankshaft. If the deviation from true is greater than 0.09 mm (0.004 inch), regrind the crankshaft. [a] Support the crankshaft on a stand, held by the two external journals. [b] Set up a dial gauge and holder on the center journal, with some preload on the gauge. [c] Set the dial gauge to "0" (zero).

[d] Turn the crankshaft through one full revolution, and check the dial gauge. If the dial gauge deviates by more than 0.09 mm (0.004 in.), regrind the crankshaft. All information subject to change without notice.

1-70 DDC-SVC-MAN-0026 Copyright © 2011 DETROIT DIESEL CORPORATION Description Specification in mm (in.)* Main Bearing and Connecting Rod Journal Hardness (Rockwell hardness) 53 to 59 HRC Permissible Deviation From True of Crankshaft† 0.09 (0.004) Permissible Out-Of-Round for Main and Connecting-Rod Bearing Journals - When New reground 0.01 (0.0004) Permissible Out-Of-Round for Main and Connecting-Rod Bearing Journals - Wear Limit 0.02 (0.0008) Fillet Radii of Main Bearing Journals 4.2-4.5 (0.165-0.177) Fillet Radii of Connecting Rod Bearing Journals 3.7-4.0 (0.146 - 0.157) Crown of Main Bearing Journals and Con- necting-Rod Journals 0.000-0.004 (0.0000-0.0002) Main Bearing Outside Diameter (diameter of bearing shell housing 111.000-111.022 (4.3701-4.3709) Permissible Imbalance of Crankshaft‡ -at 400 rpm 0.6 N·cm (0.05 lb·in)