Yamaha Motor Corporation, USA 115A/130A/L130A/150A/V150A — MAINTENANCE

E Procedure NOTE: A diagnostic tachometer should be used for this procedure. 1) Start the engine and allow it to warm up fully in Neutral until it is running smooth- ly. If the outboard is mounted on a boat, be sure the boat is tightly moored. 2) Adjust the throttle stop-screw to set the idling speed to specification (see “SPECIFICATIONS”) by turning the stop-screw clockwise to increase the idling speed, and turning it counterclock- wise to decrease the idling speed. NOTE: Correct idling-speed adjustment is only pos- sible if the engine is fully warmed-up. If not warmed up fully, the speed setting will tend to be too high.

If you have difficulty obtaining the specified idle, consult a Yamaha dealer or other qual- ified mechanic. 1 Throttle stop-screw EMK56010 CHECKING WATER TRAP UNDER ENGINE OIL TANK There is a trap at the bottom of the engine oil tank. If water or foreign matter is visible in this trap, consult a Yamaha dealer. w q 213021 1 Trap 2 Engine oil tank 4-16 q 204026*