hyundai — AW1110-AW1140 EN 05 20 1.0

Operating & maintenance manual 8.1.2 Regeneration of the Diesel engine (optional feature, depends on the exhaust gas aftertreatment) Note that the illustrations are generic and their design does not necessarily correspond to the switches in your compaction roller. The regeneration of the SCR catalytic converter serves to burn any crystallized AdBlue ® / DEF in the catalytic converter. In order to do so, the exhaust temperature is raised significantly. 1 a If necessary, the diesel engine automatically regenerates the SCR catalytic converter. This prevents a power loss, which means you can continue your work with the compaction roller.

b c The release button “Regeneration“ ( 1 ) in the control panel of the right armrest needs to be in the middle position ( b ). The HEST lamp and the ”Regeneration“ symbol light up on the display. You can postpone the regeneration process to a later point in time. In order to do so, press the bottom end ( c ) of the release button. The ”Regeneration off“ symbol lights up on the display. However, postponing the regeneration should be avoided, unless an increased engine temperature presents a serious danger. The engine electronics record the load spectrum and determine the point in time when the initiation of the regeneration becomes inevitable.

For the regeneration process, the engine sets itself to park regeneration and the diesel engine speed is set to 1200 rpm. The “regeneration” symbol and the general fault message for the diesel engine light up on the display. Fig. 3 Regeneration Park the vehicle and actuate the top of the release button “regeneration“. The “regeneration” symbol flashes on the display. During the regeneration process, you cannot work with the compaction roller. After completing the park regeneration, the full capacity of the diesel engine is available again.

Manual initiation of the regeneration (by pressing the top end a of the button) is possible only in case the automatic initiation of the regeneration process was previously prevented (i.e. c was pressed) or if the automatic regeneration process was not completed, e.g. due to a shutdown of the machine in the course of the regeneration process. As long as no regeneration is necessary, the regeneration process cannot be initiated manually. 42