Operating & maintenance manual 9.2.1 Trouble-shooting: Diesel engine start If the diesel engine does not start, make sure that: x the parking brake is applied x the battery main switch (if installed) is switched on x the battery is sufficiently charged x there is enough Diesel in the fuel tank x the engine compartment is faultless by performing a visual inspection x the emergency stop switch If the problem persists, contact the Hyundai service staff. 9.3 Driving the compaction roller 9.3.1 Forward motion: start 1. Deactivate (i.e. release) the parking brake by means of the switch. The symbol indicating the activation of the parking brake goes out.
Please note that, for safety reasons, after releasing the brake, you need to wait for a few seconds before the joystick can be moved out of its neutral (middle) position. 2. Make sure that the selector switch for setting the type of vibration is in the middle position 0 . 3. By means of the buttons on the joystick (or the hand gas lever, depending on your compaction roller type), set the Diesel engine speed for driving. 4. Select the operating mode: Fig. 4 Forward motion 5. Hold on to the steering wheel. 6. Move the joystick ( 1 ) forward.The symbol indicating forward motion lights up on the dashboard. The compaction roller starts to move forward. 49 WARNING Risk of accidents and injuries!
• Always fasten the safety belt before driving the compaction roller! • Driving the compaction roller with the door open is strictly prohibited! • You may open the windows before starting. Turtle Slow speed, front of the switch pressed down Rabbit High speed, rear of the switch pressed down NOTICE • The farther you move the joystick forwards, the higher the speed of the compaction roller. • As soon as the joystick has reached the end position, maximum speed is set. • In the middle (neutral) position, the compaction roller stops.