Operating & maintenance manual 9.5.2 Taking action against fogged up or icy windows 1. If the windows are fogged up, set the fan to the highest stage by means of the corresponding rotary switch ( 12 ). 2. Set the rotary switch for the heating ( 13 ) to the red area. 3. Adjust the air nozzles so the warm air flow points to the cab windows. 4. In case the rear window is fogged up, actuate the switch for the rear window defroster ( 10 ) on the panel at the cab roof. 12 13 Fig. 51 Fogged up windows 9.5.3 Heating & ventilation 12 13 The heating is fed by the warm cooling water of the Diesel engine. 1. Use the rotary switch for the fan to set the fan to the desired stage. 2.
Set the rotary switch for the heating to the red area. 3. Adjust the air nozzles to distribute the warm air in the cab. Warm air enters the cab as it flows through the ventilation slots at the cab windows and below the driver‘s seat. The filter mat in the air intake opening needs to be clean (see chapters on maintenance for further information) to ensure an unrestricted air supply for the fan. Ventilation (A/C as an optional feature) Fig. 52 Heating & ventilation 9.5.4 Line-of-sight obstruction In order to compensate for the drawbacks caused by line-of sight obstruction, the following measures are to be taken: Find a skilled person to give you the required instructions and hand signals.
Block access to the operating area of the compaction roller. Fig. 53 Giving hand signals & instructions 53 SAFETY S Obligation to inform yourself! x In countries where official regulations concerning this issue exist, a special permit must be obtained. x The control elements of the vehicle must allow for easy and safe operation. x A sufficient field of vision must be ensured for the driver at all times, regardless of the operating and weather conditions. INSTRUCTION