Operating & maintenance manual 12.3 Carrying out the towing process x Always fasten the compaction roller on both points of attachment at the front ( 1 ) and at the rear ( 2 ) of the vehicle. x Secure the compaction roller against rolling by establishing the connection with the towing vehicle. x Remove the wheel chocks and the additional safety equipment used from the roller drum and the tires. x Keep the towing distance as short as possible. 1 2 )LJ 67 )DVWHQLQJWKHFRPSDFWLRQUROOHU 12.3.1 After towing Closing the HP valves:
After the towing process, the hydraulic circuit between the traction pump and the traction motor must be closed and the parking brake needs to be put in working order again. Access the HP valves from the left side of the engine compartment (direction of motion). In order to activate the HP valves ( 1 and 2 ), you need a socket head wrench (WW 4). Use the wrench to loosen the adjusting spindles until they have reached their initial position. Attach the protecting caps. 4 mm socket head wrench 1 2 Fig. 68 Closing the HP valves 62 WARNING Towing distance and speed x The compaction roller may only be towed within the working zone.
x The towing distance is to be kept as short as possible and may not exceed 500 meters (546 yards)! x Before starting the towing process, make sure the necessary preparations concerning the driving hydraulics and the parking brake have been completed. x Set the towing vehicle in motion very slowly (max. towing speed 1 km/h / 0.6 mph). DANGER Risk of death Immediately after completing the towing process, secure the compaction roller against rolling by means of the wheel chocks and further equipment, if required.