Operating & maintenance manual 12.2.2 Releasing the parking brake and the HP valves In order to tow the compaction roller, short-circuit the hydraulic circuit between the traction pump and the hydraulic traction motors. Access the HP valves from the left side of the engine compartment (in the direction of motion). You need a socket head wrench (size WW 4 ) to loosen the HP valves ( 1 ) and ( 2 ). Unscrew the protecting caps. Use the socket head wrench to screw in the adjusting spindles until they are level with the valve housing. 4 mm socket head wrench 1 2 Fig.
65 Opening the HP valves 12.2.3 Deactivating (releasing) the parking brake In order to tow the compaction roller, you need to release the parking brake in the rear axle and in the drum via the hand pump ( 5 ). The hand pump ( 5 ) is installed in the engine compartment (on the right side, in the direction of motion). Actuate the release valve ( 4 ). Put a pipe extension into the pump actuation ( 3 ). Build up pressure by manually pumping, which releases the parking brake. • The light for “Drive control diagnosis” starts to flash as soon as the ignition is activated and the switch for the parking brake is actuated. 3 4 5 Fig. 66 Deactivating the parking brake 61 DANGER Risk of death!
If the compaction roller is not properly secured against rolling, you must not carry out any of the work described below.