hyundai — AW1110-AW1140 EN 05 20 1.0

Operating & maintenance manual Step 5: Backing up the compaction roller Slowly back up the compaction roller again. Fig. 90 Backing up the compaction roller Step 6: Mounting the third segment x Position the third segment carefully. x Screw the third segment to the two previously mounted segments. x Remove the fixing clamps of the first two segments from the edges of the smooth drum. Step 7: Establishing the screw connections at the segment junctions Repeatedly drive the compaction roller forward and backward so the segment junctions point upward. Evenly tighten the screws at all segment junctions along the entire width of the drum.

Check all screw connections at the junctions ( 9 ) and tighten them (tightening torque: 660 Nm) . Fig. 92 Screw connections Step 8: Mounting the pad foot scrapers Install the corresponding pad foot scrapers ( 11 ) in order to use the drum as a pad foot roller ( 6 ). Make sure there is enough space. 11 6 11 77 Fig. 91 Third segment Fig. 93 Mounting the pad foot segments NOTICE After approx. 10 hours of operation, check all screw connections again (9). If necessary, tighten them. Tightening torque: 660 Nm.