hyundai — AW1110-AW1140 EN 05 20 1.0

Operating & maintenance manual 16 Tires on the rear axle 16.1.1 Water filling of the tires (optional) In order to improve the propulsional properties of the tires on the rear axle, on delivery, they are filled with water and an additive composed of magnesium chloride which serves as antifreeze. 16.1.2 Filling procedure: Water and antifreeze additive Lift the compaction roller at the rear axle by means of a sufficiently dimensioned hydraulic jack. Turn the tire ( 1 ) until the charge valve (2) is in the top position. Slowly unscrew the valve core ( 3 ). Screw a hose line ( 4 ) onto the charge valve ( 2 ).

The saline solution (see “Preparation of the saline solution below) can be poured into the tire ( 1 ) by means of a container placed above the tire or via a special pump. The filling procedure ( 5 ) must be interrupted repeatedly because the tire needs to be bled. In case the tire is not sufficiently filled after pouring in the saline solution, add industrial water to establish the required fill level. After completing the process, attach the valve core ( 3 ) and fill the tire ( 1 ) with compressed air. Prescribed pressure: 1.6 bar (23.2 psi) for standard tires. 1 2 3 Preparation of the saline solution: Mix magnesium chloride and water at a weight ratio of 1:1 in a clean container.

Stir until the salt has completely dissolved. Always add the salt to the water, never vice versa. 4 3 5 Fig. 94 Filling the tires 78 • NOTICE • Magnesium chloride is commercially available granulated salt with a 47% share of dry substance which can be purchased at (chemical) wholesale. In countries where the exterior temperatures never fall below zero degrees Celsius, the tires can be filled with industrial water, without any additives. • NOTICE • • Since air must be exhausted from the tire (5), repeatedly interrupt the filling process. As soon as the level of water/saline solution has reached 75% of the volume of the tire (i.e.

it is on a level with the charge valve), stop the filling process. The remaining air in the upper part of the tire is essential to ensuring its springiness. As soon as the required fill level of 75% has been reached, the saline solution must not leak from the tire with the charge valve (2) opened.