Komatsu 95-2 DIESEL ENGINE — 4. MAIN CAP

DISASSEMBLY AND ASSEMBLY OVERALL ASSEMBLY 5) Assemble piston and connecting rod assem- bly as follows. i) Assembly of piston and connecting rod assembly. Using push tool @ (outside diameter: 32 mm), press fit bushing (9) to connecting rod. ii) Set face with stamped mark on end gap facing up (compression ring only), then use piston ring tool E to assemble each piston ring (8). * Be careful not to damage the piston or break the ring. * Fit the expander in the groove on the inside diameter, then assemble the oil ring. When doing this, check that the expander is completely fitted in the ring groove. * Set so that the end gap of the ring is at 180" to the join of the coil of the ex- pander.

iii) Using pliers @, assemble one snap ring (4) in snap ring groove on piston. Ir Set the [FI mark on the piston pin boss surface facing in the same di- rection as the casting number on the connecting rod, then insert piston pin (6) and assemble connecting rod (7) and piston (5). Assemble the remaining snap ring to the piston. * After assembling the snap rings, check that the connecting rod moves smoothly forward and backward. iv) Align the protrusion of the connecting rod upper bearing and the notch on the connecting rod, then assemble. 95-2 SERIES 13-1 7