DISASSEMBLY AND ASSEMBLY OVERALL ASSEMBLY 6) Assemble piston and connecting rod assem- bly inside cylinder block. i) Turn over cylinder block, and set so that crankshaft is perpendicular. ii) Set so that the relationship between the end gaps of the piston rings is as shown in the diagram. iii) Set crankshaft to bottom dead center for cylinder where piston and connect- ing rod assembly is to be assembled. fl Coat the inside face of the cylinder, the piston rings, and the surface of the connecting rod bearing with en- gine oil. iv) Align direction of F mark on piston side surface to face front of engine.
Using piston holder H , insert piston and con- necting rod assembly (3) from cylinder head end. v) When piston rings are inserted inside cylinder liner, push in head of piston with flat of hand or wooden rod. In addition, pull in big end of connecting rod and fit in crankshaft. vi) Align protrusion of lower bearing with notch in cap, then assemble bearing to connecting rod cap (12). fl Check that there is no dirt or dust stuck to the rear face of the bearing. vii) Set so that stamped mark is at cam- shaft end, then install connecting rod cap (2). fl Coat the connecting rod bearing with engine oil.
fl Check that the stamped number on the connecting rod cap is the same as the number of the cylinder. fl Tighten mounting bolts of connect- ing rod cap as follows. fl Coat mounting bolt thread and bolt seat with engine oil. 3 Cap mounting bolt : 1st step: Tighten in turn to 39.0 Nm {4.0 kgm} 2nd step: Mark bolt head and cap seat, then turn bolt 90 to tighten. flAfter tightening, make a punch mark on the bolt head to indicate the number of times the bolt has been tightened. The bolt can be used a maximum of five times. Always re- place any bolt that already has five punch marks. flAfter assembling the connecting rods, check that the crankshaft ro- tates smoothly.
+2.0 + 0 +0.2 + 0 +30° + 0 95-2 SERIES 13-18 13-18 1