DISASSEMBLY AND ASSEMBLY OVERALL ASSEMBLY 3) Install starting motor (4). 4) Install engine stop solenoid (3). Ir Adjust clearance A. For details, see TESTING AND ADJUST- ING. 5) Fit dipstick (2) to engine block and install bracket (1 ). Ir Fill engine with oil. & Engine oil : 6 (SAE30CD) R u n n i n s S t o p III DXE00266 24. Alternator, fan pulley 1) Fit fan pulley (6) to water pump drive shaft, and tighten with mounting bolts (5). 2) Fit alternator assembly (4) to PTO housing, and install mount bolt (2). 3) Fit fan belt (31, insert a bar between alterna- tor and cylinder block, raise to outside while watching belt tension, and tighten lock bolt (1).
t Adjust so that the belt deflects the amount shown below when the belt is pressed with a finger pressure of 59.0 N {approx. 6 kg} at a point midway between the crankshaft pulley and alternator. Deflection of fan belt : 14 - 17 mm Ir After adjusting, tighten the bolts. P U I I Y A l t e r n a t o r P U I I Y I PUI I Y DXE00267 25. Engine assembly 1) Sling engine assembly (1). fi Engine assembly : 300 kg (The weight differs according to the ma- chine model.) 95-2 SERIES 13-29