Komatsu 95-2 DIESEL ENGINE — TESTING AND ADJUSTING FUEL INJECTION TIMING

TESTING AND ADJUSTING TESTING AND ADJUSTING FUEL INJECTION TIMING 7. Put dial gauge M2 in contact with the tip of the valve shaft, then rotate the crankshaft in the normal and reverse direction and set the gauge to 0 at the point where the indicator starts to turn in the reverse direction. 8. Put the No. 1 cylinder at compression top dead center, then rotate the Crankshaft approx. 45" in the reverse direction. a 9. Rotate the crankshaft in the normal direction until the dial gauge shows the standard dimen- sion a. This dimension corresponds to BTDC 12 2 0.8". * Standard dimension a: 1.69 2 0.22 mm Ir Always rotate in the normal direction when aligning. BWPO4027 IO.

Disconnect fuel injection pipe (IO) of No. 1 cyl- inder. 11. Remove delivery valve holder (111, take out de- livery valve (12) and spring (131, then install de- livery valve holder (11) again. 12. Place the fuel injection lever at the FULL posi- tion. , \ E E P 0 1 0 6 5 13. Loosen the nut in the oblong hole of the mount- ing flange of the fuel injection pump, then loosen injection pump mounting bolts (14). I I 1 3 12 / / 14. Move the fuel injection pump towards the out- side, then move the injection pump towards the cylinder block a little at a time while operating the priming pump. Stop at the point where the fuel stops flowing from the delivery valve holder.

* Adjust the fuel injection timing by moving the fuel injection pump as follows. To RETARD timing, move towards OUTSIDE To ADVANCE timing, move towards CYLIN- DER BLOCK 15. Tighten fuel injection pump mounting bolts (14) In turn. 16. Tighten the nut in the oblong hole of the injec- tion pump mounting flange. E E P 0 1 0 6 7 12-8 95-2 SERIES