TESTING AND ADJUSTING TESTING AND ADJUSTING FUEL INJECTIQN TIMING 17. Rotate the crankshaft in the normal direction and check that the indicator of the dial gauge is at 0 5 0.22 mm when the No. 1 cylinder is at top dead center (the point where the indicator of the dial gauge starts to turn in the reverse direc- tion). If this dimension is not correct, carry out the operation again from Step 7. 18. Remove delivery valve holder (111, assemble delivery valve (12) and spring (13), then install delivery valve holder (1 1) again. * Replace the O-rings and copper gaskets of the delivery valve with new parts. A Tighten the delivery valve holder securely in 3 passes.
(If the tightening is insufficient, it may cause the gasket to split.) Delivery valve holder: 32.4 = 2.0 Nm {3.3 2 0.2 kgml 19. Connect fuel injection pipe (3). Sleeve nut : 23.5 = 1.0 Nm 12.4 0.1 kgm) 20. Install valve spring (7) and spring seat (6). 21. Compress the valve spring with spring pusher MI and install valve cotter (5). 22. Assemble No. 1 cylinder intake rocker arm (41, then install snap ring (3). * Install the snap ring securely. 23. Install the cylinder head cover. Cylinder head cover mounting bolt : 8.8 = 1.0 Nm I0.9 0.1 kgml 95-2 SERIES 1 2-9