TESTING AND ADJUSTING ADJUSTING FUEL CUT SOLENOID ADJUSTING FUEL CUT SOLENOID 4D95LE-2 (For PC60-7, PC75UU-3, PC78US-6, PC78UU-6) 1 . Install ball joint (2) to solenoid (1) and tighten locknut (3). fl a : Approx. 1 mm (1 thread) 2 . Assemble rod (4) and rod end (5) temporarily to ball joint (2). fl Depth b for screwing rod into ball joint: Approx. 12.5 mm fl Depth c for screwing rod end into rod: Approx. 10.0 mm 3 . Pass electricity through solenoid (1) to make it attract.
fl When doing this, if rod end (5) and stop lever (6) of the fuel injection pump are con- nected before the solenoid is actuated, the solenoid will not be pulled away (the actuat- ing current will continue to flow) when the solenoid is actuated, and the coil will burn out. To prevent this, do not connect the rod end and stop lever. 4 . Check that solenoid (1) is attracted, then con- nect rod end (5) to stop lever (6), and adjust the length of rod (4) so that the stop lever contacts the end of the lever at the constant end. 12-10 3 95-2 SERIES