Komatsu 95-2 DIESEL ENGINE — ADJUSTING FUEL CUT SOLENOID

TESTING AND ADJUSTING ADJUSTING FUEL CUT SOLENOID fl Stop lever (6) contacts the end of the lever at the constant end. (Contacts inside the in- jection pump) fl Play: 0 mm fl When adjusting the length of rod (4), do not apply any excessive force to pull stop lever (6) beyond the lever end. fl The method for adjusting the rod length is as shown in the diagram on the right. 5 . Tighten nut (7) at the connection of stop lever (6) and rod end (5), then install a split pin. fl Install the rod end so that greasing port (8) is at the top. 2 Rod end: Grease (G2-LI) 95-2 SERIES 12-11 12-11 1