12. Heat planetary gear and place it on the planetary carrier. NOTE: Pay attention to the installation position, large radius of the inner bearing race must be facing the planetary carrier (downwards). Figure 143 13. Squeeze in circlip. Figure 144 Determine Sun-gear Shaft Play Normal value 0. 3 - 0.6 mm (0.0118 - 0.0236 in), try to fine the higher value. 1. Place sun gear and plate carrier against shoulder. Dimension A e.g. 6.00 mm (0.2362 in). Figure 145 2. Determine dimension B from the flange- mounted surface to the thrust washer. Dimension B e.g. 5.50 mm (0.2165 in). NOTE: For the measurement, lay thrust washer into the planetary carrier. Figure 146 S0602170K Page 70 Axle (ZF AP 420R)