MAN — DDC-SVC-MAN-0056 - MBE4000 Safe Operation and Preventative Maintenance Manual

EPA04 MBE 4000 ENGINE OPERATOR'S GUIDE The two control units are connected by a proprietary datalink through which all necessary data and information can be exchanged. The DDEC-VCU then broadcasts all information on the J1587 and J1939 datalinks, where it can be read by minidiag2, the Nexiq™ Diagnostic Data Reader (DDR) or Detroit Diesel Diagnostic Link® (DDDL) PC software. The DDEC-ECU monitors both the engine and the datalink. When a malfunction or other problem is detected, the system selects an appropriate response; for example, the emergency running mode may be activated.

For more information on the emergency running mode, refer to the “Emergency Running Mode” section under “Operations.” Figure 9 DDEC-ECU These data are evaluated together with the data from the sensors on the engine, such as coolant and fuel temperature and oil and charge pressure. The data is then compared to the characteristic maps or lines stored in the DDEC-ECU. DDEC-ECU Engine-Resident Control Unit From these data, quantity and timing of injection are calculated and the unit pumps are actuated accordingly through the solenoid valves. The DDEC-ECU (see see Figure 9) is located on the left-hand side of the engine.

The DDEC-ECU processes the data received from the DDEC-VCU, for example the position of the accelerator pedal, engine brake, etc. NOTE: To obtain a replacement DDEC-ECU, all the data given on the DDEC-ECU label are required. The DDEC-ECU data label has the 10 digit engine serial number (see Figure 6), the engine horse power and torque. All information subject to change without notice. (Rev. 04/08) 19 DDC-SVC-MAN-0056 04/08 Copyright © 2008 DETROIT DIESEL CORPORATION