IDENTIFICATION Vehicle Control Unit and transmitted to the DDEC-ECU via the proprietary data link. The DDEC-VCU, see Figure 10, communicates with the other electronic control units installed on the vehicle over the J1587 and J1939 data link. The DDEC-VCU controls various systems, for example, communications with the datalink and the engine brake. If the engine control system detects a fault, the appropriate fault code is broadcast on the datalink and can be read using minidiag2, the Nexiq DDR or DDDL PC software. Fault code information may also be available on the vehicle or equipment instrument panel. Sensor Locations Use caution when handling the sensors.
Figure 10 DDEC-VCU Sets of data for specific applications are stored in the DDEC-VCU including idle speed, maximum running speed, and speed limitation. CHEMICAL BURNS The DDEC-VCU receives data from the following sources: To avoid injury from chemical burns, wear a face shield and neoprene or PVC gloves when handling sensor hoses. The operator (accelerator pedal position, engine brake switch) Other electronic control units (the antilock brake system) The Engine Oil Pressure/Temperature Sensor is located at the base of the oil filter. The DDEC-ECU (oil pressure and coolant temperature) See Figure 11 for sensor locations on the MBE 4000 engine.
From these data, instructions are computed for controlling the engine 20 All information subject to change without notice. (Rev. 04/08) DDC-SVC-MAN-0056 04/08 Copyright © 2008 DETROIT DIESEL CORPORATION