MAN — DDC-SVC-MAN-0056 - MBE4000 Safe Operation and Preventative Maintenance Manual

OPERATION Checking the Coolant Level (Cold Check) Correct torque on the high pressure lines is critical. Incorrect torques could result in leaks or lack of power due to restricted fuel flow. NOTICE: Check coolant level as follows: 1. Ensure that all coolant plugs in the bottom of the radiator and on the radiator outlet pipe are secure and tight. 1. Make sure that all high-pressure and low-pressure lines are securely tightened. For tightening specifications, refer to the ”Technical Data” section. 2. Check the coolant level. The cooling system is correctly filled when the coolant is between the maximum and minimum marks on the surge tank. 2.

If equipped with a hand pump on the fuel/water separator, work the hand pump 50 times. For more information, refer to the “Maintenance” section. Adding Fuel NOTE: There should be a strong resistance in the hand pump, caused by the pressure buildup within the fuel system. When adding fuel, pay attention to the following: Add winter or summer grade fuel according to the season of the year. 3. Crank the engine for 30 seconds at a time, but no longer. Wait at least two minutes. The engine should start within four 30-second attempts. Work in the cleanest conditions possible. Prevent water from entering the fuel tank. For further information, refer to the “Service Products” section.

Priming the Fuel System Prime the fuel system as follows: 24 All information subject to change without notice. (Rev. 04/08) DDC-SVC-MAN-0056 04/08 Copyright © 2008 DETROIT DIESEL CORPORATION